Pro-M Drop-In Sensor

$174.95
SKU
DROPIN

Maximum 10 characters

Maximum 10 characters

Maximum 255 characters

Use the Pro-M Drop-In Sensor with our Drop-In Weld-On Flange to create your own custom mass air meter assembly. A great option for customers with custom tubes or forced induction! Please note that the drop in sensor is not intended to be a replacement sensor for a mass air meter assembly. If you have a mass air meter you believe is not functioning properly, please see the “services” section of the website.

Use the Pro-M Drop-In Sensor with our Drop-In Weld-On Flange to create your own custom mass air meter assembly. A great option for customers with custom tubes or forced induction! Please note that the drop in sensor is not intended to be a replacement sensor for a mass air meter assembly. If you have a mass air meter you believe is not functioning properly, please see the “services” section of the website. 

You will receive a Pro-M Drop-In Sensor calibrated in the tube size selected. Tuning is always required when you create you own tube, and Pro-M racing cannot be held responsible for the quality and/or performance of your design. 

Don't forget to add a flange, adapter or pigtail if needed to complete your setup! 

Wiring Diagram
Pin A: 12 Volt Power
Pin B: Battery Ground
Pin C: Mass Air Signal Ground
Pin D: Mass Air Sensor 0-5 Volt Signal
Pin E: Intake Air Temperature (IAT) Signal
Pin F: Intake Air Temperature (IAT) Ground

Copyright © 2005-present Mass-Flo EFI, Inc. & Pro-M Racing, Inc. All rights reserved. Mass-Flo EFI, Inc 77 Snow Road, West Brookfield, MA 01585