Pro-M Slot Style Mass Air Sensor

$199.99
SKU
SSSENSOR

Pro-M "Slot Style" Mass Air Sensor

The Pro-M "Slot Style" mass air sensor used in all 05 and up voltage based Ford products. It can also be used in any voltage based vehicle and comes with a 30 point transfer function sheet at NO additional charge!

Pro-M Slot Style Mass Air Sensor 

The Pro-M Slot Style mass air sensor can be used in two ways: 

1. As a direct replacement for the original sensor used in all 05 and up voltage based Ford products. The Pro-M sensor has three times more range than the stock sensor, and over 30 percent more range than our competitors product. The sensors extended range allows it to be used with engines with as much as 800 flywheel horsepower, while still using the stock air cleaner box. This sensor absolutely will not peg, yet still has excellent resolution. Tuning is required, and a 30 point transfer function sheet is provided with each sensor. 

2. As an addition to fabricated ducting. Due to its design, this sensor can easily be added to any piece of existing ducting. It can be used in both "blow through" and "draw through" applications, and has over 30 percent more range than our competitor's product. The sensor is calibrated so that its range just slightly exceeds that of the ducting in which it is installed. This means that the sensor cannot peg, yet still has excellent resolution. Tuning is required, and a 30 point transfer function sheet is included. The transfer function sheet shows the transfer function that the sensor will have in whatever diameter duct you've chosen. It will support up to 800hp in a 3" diameter tube, up to 1100hpin a 3.5 diameter tube, and up to 1500hp in a 4" diameter tube. In this application you may need the Slot Style Pigtail.

This sensor is far superior to range extenders used with the stock sensor. For more information on the limitations of range extenders, please see our range extender facts page on this website. 

Wiring Diagram
Pin A(6): 12 Volt Power
Pin B(5): Ground
Pin C(4): Mass Air Signal Ground
Pin D(3): Mass Air Sensor 0-5 Volt Signal
Pin E(2): Intake Air Temperature (IAT) 0-5 Volt Signal
Pin F(1): Intake Air Temperature (IAT) Ground

Copyright © 2005-present Mass-Flo EFI, Inc. & Pro-M Racing, Inc. All rights reserved. Mass-Flo EFI, Inc 77 Snow Road, West Brookfield, MA 01585