75mm Flanged Bullet
The Pro-M 75mm Flanged Bullet is a direct replacement for the 94-95 Mustang (Forth Generation / Fox-4 / SN-95), 94-96 5.0 and 5.8 trucks, and any other Ford vehicle originally equipped with a 70mm flanged housing.
The Pro-M 75mm Flanged Bullet is a direct replacement for the 94-95 Mustang (Forth Generation / Fox-4 / SN-95), 94-96 5.0 and 5.8 trucks, and any other Ford vehicle originally equipped with a 70mm flanged housing.
The Flanged Bullet features a more modern sampling element than was originally used on the production meters, and our calibration process results in a meter with a tolerance three times tighter than the OEM.
The Plastic Flanged Bullet is built in a high quality polymer housing and is available in calibrations for use with up to 42# injectors, supporting as much as 550 flywheel horsepower.
Your new Pro-M Mass Air Meter is shipped to you with a Flow Data Sheet that was generated by your mass air meter on one of our flow benches. This flow sheet verifies that your new Pro-M Mass Air Meter was not only properly calibrated, but also functioning properly just minutes before it was boxed and shipped from our facility. This virtually eliminates the possibility of receiving a defective part. No one else does this!
If you are unsure which meter best suits your needs, or if your vehicle is not listed, please give us a call and we will assist you.
Every Pro-M mass air meter plugs into your vehicle's harness connector without modification. Be sure to read our Cold Air Intake Facts page if you are unsure about your calibration.
All Pro-M Mass Air Meters can be recalibrated, unlike the competition's "disposable" meters.
Application Guide:
1994 - 1995 Mustang GT / LX /Cobra
1994 - 1997 5.0/5.8 Ford Truck
1996 - 1999 Crown Victoria / Grand Marquis / Towncar
1990 - 1991 Ranger 2.3
1990 - 2000 Ranger 4.0
1992 - 2003 Australian Falcon / GT
Wiring Diagram
Pin A: 12 Volt Power
Pin B: Ground
Pin C: Mass Air Signal Ground
Pin D: Mass Air Sensor 0-5 Volt Signal
Pin E: Intake Air Temperature (IAT) 0-5 Volt Signal
Pin F: Intake Air Temperature (IAT) Ground
Featured | No |
---|