95MM Aluminum Flanged

$314.95
SKU
95MFA

Maximum 255 characters

The 95mm Flanged Mass Air Meter is a direct replacement for 90mm OEM meters found in 03-04 Cobra Mustangs, 01-03 Lightning trucks, and Harley Davidson trucks. The 95mm can also be used as a replacement for the 80mm OEM meters found in 96-2004 Mustangs and Ford trucks, as well as several other Ford vehicles.

The 95mm Flanged Mass Air Meter is a direct replacement for 90mm OEM meters found in 03-04 Cobra Mustangs, 01-03 Lightning trucks, and Harley Davidson trucks. The 95mm can also be used as a replacement for the 80mm OEM meters found in 96-2004 Mustangs and Ford trucks, as well as several other Ford vehicles. 

The 95mm flanged meter is made of billet aluminum. Our calibration process results in a meter with a tolerance three times tighter than the OEM.

The 95mm Flanged is recommended for for use with up to 80# injectors and supports as much as 800 flywheel horsepower.

Your new Pro-M Mass Air Meter is shipped to you with a Flow Data Sheet that was generated by your mass air meter on one of our flow benches. This flow sheet verifies that your new Pro-M Mass Air Meter was not only properly calibrated, but also functioning properly just minutes before it was boxed and shipped from our facility. This virtually eliminates the possibility of receiving a defective part. No one else does this!

If you are unsure which meter best suits your needs, or if your vehicle is not listed, please give us a call and we will assist you. 

Every Pro-M mass air meter plugs into your vehicle's harness connector without modification. Be sure to read our Cold Air Intake Factspage if you are unsure about your calibration.

All Pro-M Mass Air Meters can be recalibrated, unlike the competition's "disposable" meters.

More Information
Featured No
Copyright © 2023 Mass-Flo EFI, Inc. & Pro-M Racing, Inc. All rights reserved. Mass-Flo EFI, Inc 77 Snow Road, West Brookfield, MA 01585